public:presentation:presentation-402 [CERGE-EI Infrastructure Services]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== AV Equipment - Room #402 ======

----

{{:public:public:presentation_equipment_room_402.pdf|"One Pager" PDF available for download}} \\
…contains complete AV equipment handling overview. Also available in paper form in the classroom.

----

===== TECHNICAL INSTRUCTIONS – Start / End the presentation =====

==== Start presentation ====

<font 11.0pt/inherit;;inherit;;inherit>①</font> Touch the Lectern Control Panel – it wakes up immediately

<font 11.0pt/inherit;;inherit;;inherit>②</font> Press the button** “Press for local presentation”** to start…

   * Left and Right projectors are turned on automatically, Lectern PC/Laptop is selected as a source of the presentation
  * During the presentation you may:
      * Turn ON/OFF the Side Display and then select its signal source (HDMI) //(see column “Side Display” → “Power ON/OFF” + select signal source with “Present from”)//
      * Adjust Master Volume and Mute sound //(Slider at the right side of the Control Panel)//
      * Turn the Lights and Shades ON/OFF //(touch button “Lights & Shades” to see the sub-menu)//
      * Adjust audio Setup to change sound levels of presentation etc. //(touch button “Audio setup”)//

==== End presentation ====

<font 11.0pt/inherit;;inherit;;inherit>③ **After your presentation, __turn off__ the equipment:**</font>

  * Touch **“Power OFF”**  button at the upper right corner //(“Power Control” menu appears)//
  * Touch **“System OFF”**  button in the middle of the screen to completely shut down AV equipment
  * Finally turn off the presentation PC //(placed in Lectern)//

==== Reset EVERYTHING to DEFAULT ====

<font inherit/inherit;;#d35400;;inherit>**To reset to DEFAULT (start-up) setup:**</font> turn the System OFF, wait for 2 minutes and turn it ON again

**Note:**  There is a 2 minutes cool-down period after you turn projectors off \\ //(it is NOT possible to turn projectors ON again before they properly cool down)//